Marine heating system Installation Instructions
© Webasto Global Comfort Solutions
®
17
7.5 Fuel filter
Use of a fuel filter is necessary for protecting from contamination. Install before the metering
pump.
If installing in the engine compartment, use only fire-resistant types in accordance with ISO 7840.
7.6 Auxiliary tank
If an auxiliary tank is required for the heating system fuel supply:
installation only by a specialist in marina applications (know-how about applicable standards,
regulations and directives).
7.7 Special instruction for petrol-driven heaters in boats
WARNING!
The inappropriate installation of a petrol-driven heater in a petrol-driven boat increases
the fire hazard. Local regulations as well as special safety measures are to be
observed.
Installation of a petrol-driven heater is only to be carried out by an authorized Webasto
®
Partner
and/or with the direct support of Webasto
®
!
• The motor compartment of petrol-driven boats and ships must be vented before the heating
system is started. Appropriate stickers must be affixed close to the controls.
• Do not install heating systems where flammable vapors can accumulate.
• The combustion air intake must come from the outside, not from the engine compartment.
• Components with a surface temperature > 80°C are not permitted – use insulation.
• Install the metering pump in the coolest place possible <20°C
Petrol-driven air heating systems are not covered in this documentation. If necessary, consult with
Webasto
®
.
To Next Page
Loading...
Need help?
General
