EasyManuals Logo
Home>Webasto>Automobile Accessories>Go

Webasto Go User Manual

Webasto Go
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
3 | Technical data
4 / 12 5911743-A-01 Webasto Go
WARNING
If the cable becomes separated from the control box or
the charger coupler, DO NOT ATTEMPT TO REPAIR THE
CABLE YOURSELF. Contact your local Webasto dealer
for assistance. You can find your nearest dealer at: ht-
tps://dealerlocator.webasto.com/en-int.
WARNING
When using your Webasto Go Mobile Charger, you
must follow the following basic precautions amongst
others:
u
See the warnings on charger cord label. Read the
warnings before operating the product for the first
time. Read all instructions in this guide before using
this product.
u
Never use the charger with an extension cord.
u
Do not plug into worn or severely degraded plugs.
u
Shock hazard – be sure the plug is fully inserted into
the wall socket so that there are no exposed blade
surfaces.
u
Children should be supervised when in the vicinity of
the charger while plugged in.
u
Do not insert fingers into the electric charge
coupler.
u
Do not use in a commercial garage classified for in-
ternal combustion engine vehicles due to gasses of
flammable liquids (fuels) being present.
CAUTION
Do not connect or disconnect any pluggable compon-
ent (adapter) of the Webasto Go Mobile Charger while
the IC-CPD (control box) is in use or charging (adapter
plug connected in a wall socket or the vehicle coupler
connector is engaged in a vehicle inlet).
CAUTION
Do not operate the Webasto Go Mobile Charger in
temperature outside its operation range of -22°F to
+122°F (-30°C to +50°C).
CAUTION
Store the Webasto Go Mobile Charger in a clean dry
place in temperature between of -22°F to +185°F
(-30°C to +85°C).
CAUTION
To reduce the risk of fire, connect only to a circuit
provided with 40 amperes maximum branch circuit
overcurrent protection in accordance with the National
Electrical Code.
2.3 High voltage warning
DANGER
High voltage is present in your electric meter housing
and power distribution service panel. Contact with high
voltage can cause death or serious personal injury.
DANGER
Risk of electric shock
Parts inside this product are a risk of shock to persons.
WARNING
DO NOT operate your charger with a damaged adapter,
cable, charger coupler, or control box. Visually inspect
the cable, charge coupler, and charger module for dam-
age before each use. Do not operate if any visual dam-
age is apparent anywhere and contact your contractual
partner.
WARNING
ALWAYS position the charger cable so that it will not
be driven over, stepped on, tripped over, or otherwise
damaged or stressed. To prevent personal injury and
damage to the charger, ALWAYS stow the charger on
hanger or in stowage bag after use.
WARNING
Use the charger only to supply power to electric
vehicles equipped with an SAE J1772 or IEC 62196-2
compliant vehicle receptacle. For more information,
refer to the vehicle owner’s manual.
NOTE
Disconnect the charger from the wall socket before
cleaning it. To clean the charger, wipe it with a clean
cloth dampened with water or a mild detergent solu-
tion suitable for use on automobile paint. Do not use
chemicals or solvents. Do not submerge the charger in
any type of fluid.
2.4 Safety information
WARNING
This product contains a chemical known to the State of
California to cause cancer or birth defects or other re-
productive harm.
3 Technical data
3.1 Labels US
CCID Caution US Webasto
1
2
3
Fig.1 Label CCID Caution US Webasto
1
Technical specifications
2
Information
3
Warnings

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Webasto Go and is the answer not in the manual?

Webasto Go Specifications

General IconGeneral
BrandWebasto
ModelGo
CategoryAutomobile Accessories
LanguageEnglish

Related product manuals