Care instructions | 6
5911743-A-01 Webasto Go 7 / 12
NOTE
Note the following safety features chapter3.4, "Safety
features" on page 5.
1. Make sure the vehicle is in park (P).
2. Insert the adapter firmly into the control box.
3. Firmly insert the other end of the adapter into the appropri-
ate wall socket.
NOTE
You will hear an audible “click” when the adapter is
correctly inserted into the control box – make sure the
adapter is fully inserted and flush with the control box
before inserting the other end into the wall socket. Oth-
erwise, it will trigger a fault or cause a longer charge
session.
4. When the wall plug is inserted:
– The AMBER, BLUE and RED indicators will blink once.
Then the BLUE Indicator turns ON, followed by a blink of
the RED indicator. Lastly, the BLUE indicator turns OFF,
then ON again. This cycle will happen twice if a different
adapter is used from previous charge.
5. Plug the coupler into your vehicle’s charging inlet:
– Type 1 Coupler: When coupler is fully inserted there
will be an audible clicking sound.
– Type 2 Coupler: The coupler will lock in place once it is
fully inserted.
6. When charging begins:
– The BLUE Indicator will pulse on and off approximately
every two seconds.
7. When charging ends:
– The BLUE Indicator will illuminate solid blue.
8. To disconnect the coupler from the vehicle charge port:
– Type 1 Coupler: Press the release button on the
coupler, then pull the coupler away from the vehicle.
– Type 2 Coupler: Press the vehicle’s Cord Unlock But-
ton, then pull the coupler way from the vehicle.
NOTE
When plugging the charger into an unfamiliar wall
socket, it is good practice to take few minutes to ob-
serve the charging process and confirm it is supplying
the expected AC charging power before leaving the
charger unattended.
The RED Indicator will illuminate if it is not charging.
The unit will turn OFF if a breaker or infrastructure GFI
is tripped.
NOTE
For more information about how to charge your
vehicle, including charge settings and scheduling, refer
to the vehicle owner’s manual.
NOTE
The IC-CPD adaptor shall except if the adaptor is part of
the IC-CPD and pluggable IC-CPD.
The components of a pluggable IC-CPD must be discon-
nected while the IC-CPD is in use (infrastructure or the
vehicle connector is engaged in a vehicle inlet).
The IC-CPDs shall be used in accordance with their in-
structions.
5.3 Auto restart
The Auto-Restart feature helps to ensure that your vehicle will
be charged and ready for use when needed. A charge may be
interrupted if an error is detected. Charging will resume once
the error is no longer detected. The RED Indicator illuminates
during an error condition.
The exception to immediate Auto-Restart is when the interrup-
tion is due to a ground fault circuit interruption (CFCI). The char-
ger will attempt to restart 15 minutes after this happens. After a
fourth attempt to restart, the charger will shut down and the
RED Indicator will stay ON.
If the fault persists, do not continue to try to charge your
vehicle. Contact your Webasto dealer.
6 Care instructions
Do not use hard cleaners or solvents as this may damage your
Webasto Go Mobile Charger. Do not kink or place undue stress
on the charger cables. If the charger overheats, bring out of dir-
ect sunlight.
7 Moving and Storage
instructions
If improper moving or storage of the device is able to result in
damage to the product that could result in a risk of fire or elec-
tric shock during subsequent use, the instructions shall describe
the proper moving and storage procedure, and shall be pre-
ceded by the heading chapter7, "Moving and Storage instruc-
tions" on page 7 or the equivalent.
Instructions for moving the device shall state that the device is
not to be lifted or carried by either the flexible cord or the EV
cable, if provided. The appropriate means for carrying and mov-
ing the device shall be described.
Instructions for the proper storage of the device, including loca-
tion, temperature limits, and the like, shall be provided in the
Moving, Transporting and Storage Instructions.
To Next Page
Loading...
Need help?
General
