To Next Page
S
smillerAug 13, 2025
How to stop fuel odour from my Webasto Thermo Pro 50 Eco?
- JJohn WallerAug 13, 2025
If you notice a fuel odour, check the fuel level and inspect the fuel system for any leaks.
How to stop fuel odour from my Webasto Thermo Pro 50 Eco?
If you notice a fuel odour, check the fuel level and inspect the fuel system for any leaks.
What to do if my Webasto Water Heater is losing coolant?
If you are experiencing coolant loss, check the coolant level and inspect the coolant system for any leaks.
Why does my Webasto Thermo Pro 50 Eco smoke during start-up?
If your heater smokes during the start-up phase, check the fuel level, bleed the fuel system, and inspect the combustion air/exhaust pipe for any foreign bodies.
What to do if my Webasto Thermo Pro 50 Eco Water Heater shuts off too early?
If your heater starts but switches off prematurely, check the fuel level, bleed the fuel system, and inspect the combustion air/exhaust pipe for foreign bodies.
How to get rid of exhaust smell inside my car when using Webasto Water Heater?
If you notice exhaust odour inside the vehicle, inspect the exhaust system for leaks.
What should I do if my Webasto Thermo Pro 50 Eco Water Heater is overheating?
If your heater is overheating, check the coolant level and bleed the coolant circuit.
What to do if the exhaust gas temperature is too high on my Webasto Thermo Pro 50 Eco Water Heater?
If the exhaust gas temperature is too high, check the burner unit and heat exchanger for clogging; clean or replace if necessary.
What does it mean if flame was detected prior to combustion in Webasto Thermo Pro 50 Eco?
If flame was detected prior to combustion, the exhaust temperature sensor may be defective. Perform a functional check of the exhaust temperature sensor and replace it if necessary.
Details the functionality and connection of the 24 Volt toggle switch for heater control.
Explains the menu options and settings for the SmarTemp Control fx unit.
Step-by-step instructions to manually reset the heater after a fault lock-out.
Details the functionality and connection of the 24 Volt toggle switch for heater control.
Explains the menu options and settings for the SmarTemp Control fx unit.
Step-by-step instructions to manually reset the heater after a fault lock-out.
General| Heating Power | 5 kW |
|---|---|
| Fuel Type | Diesel |
| Voltage | 12V / 24V |
| Application | boats |
| Fuel Consumption | 0.6 l/h |
| Operating Temperature Range | -40°C to +40°C |
