Webasto Thermo & Comfort N.A., Inc. 34 www.techwebasto.com
Initial Start-up Thermo Pro 90
13. Initial Start-up
IMPORTANT!
Refer to the safety instructions in the operating and maintenance instructions.
The operating and maintenance instructions must be read thoroughly before starting the heater.
HEATER MOUNTING Complete
(Yes/No/Comments)
1 Is the heater installation safely secure / rigid?
(Ensure that all bracket bolts are tight)
2
Is there a safe clearance from heat generating
Components? (I.e. exhaust, etc...)
3 Is there sufficient clearance between heater and any
vehicle moving components under all operating
conditions? (steering cranked to extreme positions,
torqued engine, suspension, etc...)
4 Is the heater mounted in an acceptable position
according to the limitations noted in the
installation manual?
5 Is the heater installed in a protected location from
road debris and splash-water or items stored in the same area?
6 Is there a sufficient amount clearance
between the heater and the ground? (Coolant heaters only)
COOLANT SYSTEM Complete (Yes/No/
Comments)
1 Is there a safe clearance (min 4 in.) from heat generating components?
(exhaust, etc...)
2 Is there a safe clearance from sharp edges / objects?
Ensure a heat protective has been installed (if applicable)
3 Are there any kinks, sharp bends or the possibility for pinched hoses or
harnesses, cuts and rub through?
4 Have all the hose clamps been properly positioned and tightened?
5
Has the coolant system been topped off and bleed per the vehicle
manufacture’s specifications for proper mixture and type?
6 Has a pressure test been performed on the coolant system under all
operating conditions?
7 Have the coolant hoses been installed so that they are below the coolant
filler cap?
8 Has the coolant flow direction been verified?
To Next Page