Dear Webasto customer!
We presume that the principle and mode of operation of your new heater has been explained
to your complete satisfaction by the workshop / service centre which installed the heater. This
manual summarizes the main points of importance for using the heaters Thermo Top E, C
and P.
The water heaters Thermo Top E, C and P have been type-tested and approved in accordance
with Directives 2001/56/EC (heaters) and 72/245/EEC (EMC) within the territory governed by
European Directive 70/156/EEC.
The units must be installed in accordance with the enclosed installation instructions.
The heater must not be operated :
• In filling stations and tank farms.
• At locations at which highly flammable gases or dusts can
form, and at locations at which highly flammable liquids or
solid materials are stored (e.g. near fuel, coal and wood
dust, grain warehouses, dry grass and leaves, cardboard ,
paper, etc.)
• In enclosed rooms (e.g. garages), not even via the timer or
Telestart.
The heater must not:
• be exposed to temperatures of more than 120 °C (storage
temperature), otherwise the electronics may suffer
permanent damage.
• be operated without at least 20% brandname anti-freeze in
the water of the heating circuit.
General information
Maintenance and safety instructions
Danger of explosion
and suffocation!
Operating and maintenance
instructions
Thermo Top E
Thermo Top C
Thermo Top P
To Next Page
Need help?
General
