30
D
Programming Telestart Transmitter
1. Place batteries into the battery compartment of the transmitter.
2. Remove fuse 1A (black) from the heater's fuse holder (voltage interruption).
3. Wait at least 5 seconds.
4. Replace fuse in heater's fuse holder and within 5 seconds press the OFF button
on the transmitter for at least 1 second.
5. Programming is completed.
A second or third hand-held transmitter can be programmed in the same manner.
NOTE:
The programming process can be repeated as often as necessary. The "oldest"
transmitter will be deleted each time.
1A
1A
min. 5 sec.
max. 5 sec. min. 1 sec.
OFF