Webb WER460SP - Replacement Parts Information

25
TRANSPORT
• Empty the petrol tank
• Always let the engine run until it has used up the remainder of petrol in the tank.
• Empty the engine oil from the warm engine.
• Remove the spark plug boot from the spark plug.
• Clean the cooling fins of the cylinder and the housing.
• Use the original packaging to ship whenever possible.
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSES
REMEDIAL ACTION
Engine does not start
Fuel tank is empty.
Fill tank with fuel: refer to ENGINE
OWNERS MANUAL.
Spark plug loose.
Tighten spark plug.
Spark plug wire loose or
disconnected from plug.
Install spark plug wire on spark
plug.
Spark plug gap is incorrect
Set correct gap between
electrodes.
Spark plug is defective.
Install new, correctly gapped plug.
Carburettor is flooded with fuel.
Remove air cleaner element and
pull starter rope continuously
until carburetor clears itself and
install air cleaner element.
Old Fuel
Fuel becomes stale after 30 days
and causes residues to build and
‘gunk up’ the carburettor. Change
fuel with fresh. If problem persists
consult local Approved Service
Dealer.
Motor speed drops off
Air filter clogged
Clean air filter: refer to relevant
section in manual
REPLACEMENT PARTS
Please find on the following pages, parts lists and drawings for your machine. Should you require a replacement
part, please call our Spares Team on 01793 333212, option 1 for assistance.
Webb recommends the use of Handy Parts oils, fuel additives, nylon lines pre-packed parts for all of items
machines.