Weber mt CR 7 - Key Switch Operation

17
8 Key switch The key switch is used to switch the power supply (ignition) to
themachineonoro󰀨.Italsoactuatestheelectricstarterofthe
engine.
Switch in position “1”
The ignition is switched on.
Switch in position “0”
Theignitionisswitchedo󰀨.
Switch in position “2”
The electric starter is actuated.
ATTENTION
Danger of material damage from running electric starter.
The ignition key must spring back from position “2” to position
“1”. Otherwise:
Shut down the machine immediately.