Weber Rescue Systems SPS 270 E-FORCE 2 - Replacing Blade Inserts (PLUS)

4.6Replacingbladeinserts(PLUS)
Duringbladereplacement,thecuerisxedinplace.Anyslippingshouldbeavoided.Replacing
thebladerequiresaso-facehammer,therollpinssupplied,apunchandthebladeinserts
themselves.Itmakessensetoreplacebothbladeinsertssothatthecungbehaviourisnot
impaired.

Thebladeinsertsshouldnotbereground,simplycleaningoanysoilis
recommended.

  Thecuerisposionedwiththetypeplatepoinng
  upwardandisxedinplace.Aclampingdevice,as
  shownintheillustraons,isnotobligatory.
  Whenthebladeinsertisbeingchanged,thebaery
  mustberemovedfromthecuerandnotunderload.
  Thismeansthattheshearisnotcompletelyopen
  orclosed.Thebladeinsertforthecuerbladewiththe
  smoothsurfacecannowbereplaced.Therollpinsare
  knockedoutanddownwardfromthepunch
  (seegure1).
Fig.1
  Aertherollpinshavebeenknockedoutof
  theirposion,thebladeinsertcanbepulledout.
  Theuseofaforkedscrewdriverisrecommended.
  Ifthebladeinsertcannotbeloosenedimmediately,
it can be gently levered out using a punch in the holes
  (seegure2).
Fig.2
