EasyManua.ls Logo

Weber Rescue Systems SPS 270 E-FORCE 2 - Intended Use; Power Line Connection; Li-Ion Battery

Weber Rescue Systems SPS 270 E-FORCE 2
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.3Intendeduse
Thischargerchargesthe28VLi-ionbaeryoftheM8/V28systemdeliveredwiththebaery-
powereddevice.Thisdevicemustbeusedonlyasspeciedandintended.
6.4 Powerlineconnecon
Onlyconnecttosingle-phaseACcurrentandonlytothelinevoltagespeciedonthetype
plate.Connecontopowersocketswithoutanearthingcontactispossible,becausethisisa
proteconclassIIdesign.
6.5 Li-ionbaery
Forsafetyreasons(airtransportregulaons),thebaeriesaredelivereduncharged.Beforerst
use,thebaerymustbecompletelycharged.
LEDchargestatusdisplay Figure1
Ifthebaeryisnotusedforaprolongedperiodofme,thebaeryswitchestostandbymode.
Touseagain,thebaerymustbereacvated(recharged).
Thechargestatuscanbecalledupbypressingthebuononthebaery(seeFig1).Todothis,
thebaerycanremaininthebaery-powereddevice,butitmustbeswitchedoatleast1
minutebeforehand(otherwisethedisplaywillnotbeaccurate).ThenumberofglowingLEDs
indicates the charge status.
Thebasicprincipleis:Ifthebaery-powereddevicedoesnotfunconaerthebaeryis
inserted,putthebaeryontothechargerfortesng.Thedisplaysonthebaeryandcharger
giveinformaonaboutthebaerychargestatus.
Atlowtemperatures,theworkcanbesllbecarriedoutwithlowerperformance.
Forbestoperaonalreadiness,thebaeriesmustbefullychargedaeruse.


Table of Contents

Related product manuals