How to fix a jagged typeface on a Weber Markoprint X1JET XR71 Printer?
If you observe a jagged typeface when printing with the Weber Printer, the print speed setting may be incorrect. Verify the speed setting, specifically the intensity setting on the rotary encoder.
What to do if there are fine gaps in the print image followed by satellite drops on my Weber Markoprint X1JET XR71 Printer?
If you're seeing fine gaps in the print image followed by satellite drops when using the Weber Printer, it could be due to paper dust, other dust, or fibers obstructing the nozzle openings. Try running a purging cycle and carefully clean the print head. If the problem persists, the print head may need to be sent in for repair.
Why is the print weak and blurred on my Weber Markoprint X1JET XR71 Printer?
A weak and blurred print from the Weber Printer can often be attributed to the distance between the print head and the object being too large. Reduce this distance to between 1 and 3 mm.
Why does ink run from the head of my Weber Markoprint X1JET XR71 Printer?
If ink is running from the Weber Printer's print head, especially when using a TOP head, this could indicate an incorrect level setting, meaning there is no horizontal installation. Additionally, air in the system can cause this issue; remove any air from the tubes or head.
Why is the Weber Printer print head not printing?
If the Weber Printer's print head isn't printing, several factors could be at play. First, ensure the printer is receiving power by checking the voltage input and the power switch. Then, verify the photo sensor connection for an LED pulse, which indicates a start pulse. Confirm that a print image has been assigned and the printing process has been initiated. Also, check the shaft encoder and its connections, looking for a red sensor LED, which would indicate a problem with the shaft encoder signal. If air has entered the ink channels, perform a purging process. Review the menu settings to ensure the system is configured correctly. Adjust the print parameters if the start signal is too early or late relative to the print object. If these steps don't resolve the issue, the print head may nee...
Explains how to use the manual, including notations and procedures.
Defines key technical terms used throughout the manual for clarity.
Provides contact information and details for obtaining technical support.
Outlines general safety rules and warnings to prevent injury and damage.
Specifies the correct usage of the system to ensure safety and reliability.
Lists required safety gear for operating and maintaining the system.
Details physical dimensions, weight, and environmental operating conditions.
Covers voltage, current consumption, and power requirements for operation.
Specifies print speed, resolution, language support, and barcode capabilities.
Lists all components included in the standard package delivery.
Provides essential conditions for storing the system and its components safely.
Offers a concise overview of the Markoprint X1JET XR71 inkjet coder.
Explains the working principle and technical details of the print head.
Outlines the different available system versions and their specifications.
Specifies environmental and site conditions necessary for proper installation.
Guides on positioning the system correctly relative to the product for optimal printing.
Details the process of connecting power, network, and other essential cables.
Provides instructions for safely connecting the system to the power source.
Outlines the step-by-step procedure for initial system setup and startup.
Describes the control panel, buttons, LEDs, and their functions.
Step-by-step guide for powering on the print system.
Details the procedure and precautions for replacing ink bottles.
Explains how to transfer print images to the system using a USB drive.
Guides on transferring print images from the iDesign software to the system.
Instructs on configuring system parameters like print start delay using iDesign software.
Provides a table of common disorders, their causes, troubleshooting steps, and responsible parties.
Step-by-step guide for safely removing the print head from the system.
Instructions for environmentally sound disposal of the system components.
Details the process for updating the system's software using a USB stick.
Explains the meaning of LED indicators during the system boot process.
A comprehensive list of all adjustable parameters with their ranges and units.
To Next Page
General
