Need help? https://cellphonesignalbooster.us Customer Support
Mon.- Fri. Hours: 7 am to 6 pm MST
800-501-3153
3
ENGLISH
Before Getting Started
Before you install your Connect 4G and
start enjoying improved cellular reception
in your facility, please do the following:
1. Read through all the installation
steps. This will help you know what to
2. Watch the YouTube video
demonstrating the Connect 4G
installation at
3. Familiarize yourself with all materials
in your product package. This will
allow you to know which pieces are
referenced in the instructions.
4. Identify the location of your best
available cellular signal. See
instructions that follow.
5. Determine the best installation
locations for your Outside Antenna,
Signal Boost, and Inside Antenna.
Test the function of your Connect 4G
Connect 4G™
Package Contents
AC Power Supply
5V / 2.5A
(Not included with some models)
(859948)
Panel Antenna Kit
Inside Panel Antenna
30’ RG6 coax cable
(311155-0630)
Outside Antenna Kit
75 Ohm Wide Band Antenna
30’ RG6 coax cable
(314475-0630)
Tools Required for Installation:
(depending on your particular installation, you will need the following tools)
1. Pole mount - 10 mm open-end wrench or adjustable wrench
2. Wall mount or Rafter mount - Drill and 3/16 inch bit, Phillips-head screwdriver
Find the Strongest Cellular Signal
Before you install your Connect 4G signal
booster, you must determine the location of
the best available cellular signal. This will
affect the location of your Outside Antenna
and will help you get the best performance
strongest signal outside your building,
typically at the highest point available, using
any of the following methods:
1. Best method:
Connect the Outside Antenna to the
Connect 4G signal booster, and the
Connect 4G to the Inside Antenna.
Have one person outside (on the roof
for best results) rotate the Outside
Antenna with a second person inside
the building near the Inside Antenna
watching the signal strength on a
phone. This allows you to read the
signal strength from nearby cell towers.
a. The person inside should have
the phone in test mode so the
numerical signal strength can be
read. This is more accurate than
Appearance of device and accessories may vary.
Wall Mount BracketPole Mount Bracket
https://cellphonesignalbooster.us
To Next Page
Loading...
Need help?
General