weBoost DRIVE SLEEK Installation Guide

ENGLISH
6
CELL PHONE SIGNAL BOOSTER DRIVE SLEEK
______
Step 4: Connect System To
Power
Connect the power to the 12V
*
CLA port on your vehicle
and route power cable back to the booster.
Connect power cable to booster port labeled .
NOTE: We recommend routing with the same path as the cradle/booster
cable (under mats and between seats). Cable clips are provided to help
route & secure the cables.
NOTE: The booster will be on whenever there is power from the 12V CLA
port. If your vehicle always has power going to this port, you may want to
unplug this when you’re not driving so the booster does not drain your
battery.
*
Only 12V ports are supported.
ANTENNA
connect power supply
to 12V port
connect
to booster
cable from power supply
cable clip
cable clip
insert phone into
cradle to boost signal

weBoost DRIVE SLEEK Specifications

General

Max Gain	23 dB
Connectors	SMA
Impedance	50 Ohms
Bands Supported	Band 12/17, Band 13, Band 5, Band 4, Band 2
Power Source	Vehicle 12V outlet