Weco Edge 550 User Manual

Dear Customer,
You have purchased an Edge 580 - Edge 550 edger and all the team at Weco would like to thank you for this
mark of your confidence.
The Edge 550 is a laboratory machine designed for opticians and is used for edging spectacle lenses.
Connected to an external server, the edger receives data relating to the assembly (shape).
We advise you to read this manual carefully and keep it near the machine in order to be able to refer to it
easily.
The information contained in this manual does not form a contract and can be modified without notice. This
document has been prepared with great care, but some unintentional errors or omissions may occur,
although every effort has been made to avoid them. Weco cannot, in any circumstances, be held responsible
for any possible operating defects that might result from such errors or omissions.
WECO DOES NOT GUARANTEE THE PERFORMANCE OF THE EDGE 580 - EDGE 550 IF THE
INSTRUCTIONS IN THIS DOCUMENT ARE NOT RESPECTD

Weco Edge 550 Specifications

General

Brand	Weco
Model	Edge 550
Category	Industrial Equipment
Language	English

Summary

1 INSTALLATION

1.1 UNPACKING THE MACHINE

1.6 PREPARING THE BENCH

1.7 WATER CONNECTIONS

1.8 ELECTRICAL CONNECTIONS

Specifications and procedure for connecting electrical peripherals to the edger.

1.9 STARTING THE EDGER

Steps for powering on and performing initial checks of the edger.

2 SAFETY PRECAUTIONS

2.1 SAFETY

General safety guidelines for both the operator and the machine.

3 UTILIZATION

3.1.2 PRESENTATION OF THE APPLICATION SCREEN

3.2 GENERAL PRINCIPLES OF USE

Outlines the standard procedure for operating the edger via a flow chart.

3.4 NORMAL USE

Provides guided examples of common jobs like Bevel finishing.

4 CONFIGURATION

4.1 PRESENTATION OF CONFIGURATION MENUS

4.2 CONFIGURATION OF FINISHING DEFAULT PARAMETERS

How to set default values for finishing parameters to save time.

4.3 PERSONALISATION OF PULL-DOWN MENUS

ADJUSTMENT OF THE SETTING VALUES

Screens for adjusting various machine settings and parameters.

4.5 CONFIGURATION OF GENERAL OPERATING PARAMETERS

Settings for defining the machine's general operating mode and parameters.

5 MAINTENANCE

5.1 PRESENTATION OF MAINTENANCE MENUS

5.3 TASK LIST

Recommended list of regular maintenance tasks for the edger.

5.4 REGULAR MAINTENANCE OF THE EDGER

Detailed procedures for routine maintenance tasks on the edger.

5.5 PREVENTIVE MAINTENANCE

Guidelines for optimizing edger lifespan through preventive measures.

5.6 ADJUSTMENTS