Wecon LX3 Series - Part 12 Output Specification

LX3 Series User Manual V2.0
6
Input circuit
components
S/ S
+
7m A
5m A
24 V
The picture is NPN connection,
if S / S connection 24V negative,
X then Positive, namely PNP
connection.
Part 12 Output Specification
Model
LX3V/ LX3VP/ LX3VE/ LX3VM
Output type
Relay
Transistor
Output circuit
components
Load
External
power supply
Programmable
Controllers
Load
External
power supply
Programmable
Controllers
Power supply
Less than AC250V/DC30V
DC5~30V
Loop insolation
Mechanical insulation
Photoelectric coupling insulation
Action
LED lights up when the
relay coil is energized
The LED lights up when the
optocoupler is driven
Max
load
Resistive
2A/point, 8A/COMx port
0.5A/point, 0.8A/4points,
0.3A/point (Y0,Y1)
Inductive
80VA
12W/DC24V, 7.2W/DC24V(Y0,Y1 )
General
100W
0.9W/DC24V, 0.9W/DC24V(Y0,Y1)
Leak current
--
0 .1mA/DC30V
Min load
DC5V 2mA (reference)
--
Response
time
ON
About 10ms
Less than 0.2ms, 5μs(Y0,Y1)
OFF
About 10ms
Less than 0.2ms, 5μs(Y0,Y1)
Out single mode
--
NPN mode
《Constitutes the output circuit》
●Please put the perceptual load and dc fly-wheel diode in parallel, otherwise it will significantly
reduce the contact life.
Reverse voltage of Fly-wheel diode is 5-10 times bigger than the load voltage, positive current
value is higher than load current.