8
If you are having issues getting your engine started, see the Troubleshooting
section on page 10 or visit myweego.com/support for further details
and assistance.
WARNING!
Exposed Metal Ja
ws May Be HOT After Use!
JUMP STARTING YOUR ENGINE
1
. Ensure your engine is completely OFF.
2. Securely connect the Smarty Clamps
®
to your Weego 70, then power ON.
3. Attach BLACK clamp to your battery’s negative (-) terminal, then the
RED clamp to your battery’s positive (+) terminal. Adjust your
Smarty Clamps
®
to achieve MAXIMUM contact with the terminals.
Poor connections will prevent you from starting your engine! Clear off any dirt
or build-up with a wire brush or a dry towel before connecting your clamps.
4. Place your Weego 70 in a secure location or suspend using the provided
hook & lanyard so it won’t fall. Check your Smarty Clamps
®
lights.
5. When you have a SOLID GREEN READY light, start your engine. If the engine
doesn’t start, turn off your vehicle and check your Smarty Clamps
®
lights.
6. After a successful start, quickly disconnect the Smar
ty Clamps
®
from
your Weego 70.
7. Detach the Smarty Clamps
®
from the battery.
8. You’re now good to go - be sure to run your engine for at least 15 minutes
before shutting it off again so it has time to recharge your battery.
To Next Page
Loading...
