9
UNDERSTANDING YOUR Smarty Clamps
®
Your Smarty Clamps
®
have a “smart” box that will help guide you through a
jump with both sight and sound. It will let you know when it is safe to jump or if
there is an error.
READY
Solid Green Light, No Sound
Smarty Clamps
®
detect that you have a good connection
and you are ready to jump.
Either you have a poor connection, or your battery voltage is
near 0 volts. Press the
BYPASS* button, when
SOLID
GREEN
light is on, start engine.
Note: If you cannot complete the jump the system voltage of
your vehicle may not be compatible with your Weego 70 (for
12V vehicles only).
*Using BYPASS feature will override safety features.
No Light/Flashing Green Light
SEE REVERSE
COOL DOWN
WAIT FOR
Flashing Red Light
The Weego battery overheats after long cranks or excessive
current draw. Detach the Smarty Clamps
®
from the battery
and give the unit up to 3 minutes to cool down. Then, repeat
steps 2-5 under Jump Starting Your Engine.
Bypass Button
Solid Red Light + Solid Beep
REVERSE +/-
You attached the Smarty Clamps
®
on the wrong
terminals. Make sure the BLACK clamp is attached to the
battery’s NEGATIVE (-) terminal, and the
RED clamp is
attached to the battery’s
POSITIVE (+) terminal. If not
attached properly, Weego 70 will not let you jump your engine.
To Next Page
Loading...