Infrared Remote Control and I/O
Expansion Module
English
CFW100 | 5
1 SAFETY INFORMATION
1.1 SAFETY WARNINGS
NOTE!
Only use the I/O expansion module and
infrared remote control (IOADR) on WEG
CFW100 series inverters with firmware
from version V2.10 up (see P023).
It is recommended to read the CFW100
user manual before installing or operating
this accessory.
This guide contains important information
for the correct understanding and proper
operation of this module.
1.2 PRELIMINARY RECOMMENDATIONS
ATTENTION!
Always disconnect the general power
supply before connecting or disconnecting
the accessories of the CFW100 frequency
inverter.
Wait for at least ten minutes for the full
discharge of the inverter.
2 GENERAL INFORMATION
This guide provides directions for the installation,
configuration and operation of the remote control and
I/O expansion module (CFW100-IOADR).
3 CONTENT OF THE PACKAGE
Upon receiving the product, check if the package
contains:
Accessory in anti-static package.
NTC Sensor with 1-meter cable.
Infrared (IR) remote control.
1.5-meter infrared receiver cable.
To Next Page
Loading...
Need help?
General