M33 PowerKit Engine Operating and Maintenance Manual
DPK-MAN-EN-M33-0000-19-12-20
Société Internationale des Moteurs Baudouin Baudouin.com
Technoparc du Brégadan, 13260 Cassis, France (T) +33 488 688 500 (F) +33 488 688 501 13 of 55
SAS au capital de 33 311 180 € │R.C. Marseille 509 985 735 │Siret 509 985 735 00026
TVA intracommunautaire: FR 79 509 985 735 │ APE: 28111 – 08
General Precautions for Operation
Before any operation or maintenance on any Baudouin product
Wear personal protective equipment (PPE) where required.
For maintenance, place a “Do not use” or similar sign on the starter switches.
Access to the equipment is only for authorised and qualified personnel.
Ensure that all guards and covers are secured in place on the engine.
Make sure that the repair premises and surrounding area are suitable for safe working.
Inspect the engine for potential hazards. Ensure there are no personnel on, under or
around the engine.
Ensure that the pipes and hoses are not worn or damaged. Pipes must be positioned,
supported and firmly fastened.
Ensure that the electrical wiring is not worn or damaged. Wiring must be positioned,
supported and firmly fastened
Remove all wiring that is redundant or unattached.
Use the proper tools for the operation being performed.
Report all necessary repairs promptly.
Remove any rings, chains and watches before starting work. Wear suitable and close-
fitting work clothes.
Remove and isolate the control panel key.
Do not perform any operation or maintenance operations which are not fully
understood.
Clear the engine of any flammable materials such as fuel, oil or debris.
Do not smoke near the engine or where flammable materials are stored.
Exhaust shields (if equipped) must be fitted correctly.
Do not expose the engine to flames.
Do not touch hot parts of an engine in operation or which has just been stopped.
Actuate the starter battery isolation switch on open position.
Switch off the circuit breaker located in engine connection box (if equipped).
Switch off engine room lock switch or emergency stop (if equipped).
For maintenance, for engines fitted with a pneumatic starter system, isolate the tanks
and drain the pipe linking the tanks to the starter.
For engines installed on an automatic start genset, select the lock position on the
selection mode of the control panel to avoid the engine from starting.
Use caution when cover plates or other components are removed. Gradually loosen
and remove bolts/nuts but do not remove the last two bolts which are located on
opposite ends of the plate. Before removing the last two bolts, pry open the plate and
gradually release the pressure.
Do not remove any hydraulic components or parts until the pressure in the system has
been relieved. Contact Baudouin for procedures required to remove hydraulic
components.
All investigations of leaking fuel, oil or other high pressure liquids must be conducted
using a screen and never with bare hands.
If fuel comes into contact with the skin, it can cause injury. Consult a doctor
immediately.
Fuel, oil and coolant contain harmful chemicals. Avoid any contact with skin and
hands.
To Next Page
Loading...
Need help?
General
