Weichai America Corp.
Revision: October 2018 17
WP10 Gas Engine Maintenance Procedures
1. Check Engine Oil
A. Ensure engine is level.
B. Pull dipstick after the engine stop running at least 5 minutes.
C. Ensure oil level is between high and low marks.
D. If the oil level is below the low mark, add additional oil as necessary.
E. Install dipstick.
Illustration 3
2. Check Coolant Level
Caution: Never remove radiator or top tank cap when coolant is hot! Burns and physical
harm may occur.
Illustration 4
A. When coolant is room temperature or below, remove pressurized cap and inspect
top tank or radiator for fluid level.
B. If engine has a sight gauge or plastic top tank, a visual level check is adequate.
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
To Next Page
Loading...
