7 Transportation
190
Operator’s Manual | 1190e | 1000441528 | 08/2022 | [en]
7.2 Loading
7.2.1 Information on loading the vehicle
WARNING
Accident hazard due to incorrect loading!
Incorrect loading can cause the vehicle to tip over, for ex-
ample. This may result in accidents that could result in seri-
ous injury or death.
► Clean the vehicle before loading or transporting it.
► Use a transport vehicle with the appropriate load-
bearing capacity.
► Pay attention to the vehicle’s operating weight.
► Proceed with special care when loading the vehicle in
conditions of snow and ice.
In order to avoid injury or accidents, observe the following
instructions when loading the vehicle.
• For safety reasons, the drive battery charge level
should be around 40% during loading and transport.
• The transport vehicle must be of sufficient size. Do not
exceed the permissible maximum height.
– Refer to chapter for the weight and dimensions of
the vehicle to be loaded see Technical Data on
page 279.
• Remove any mud, snow or ice from the tires so that
the vehicle can be safely driven onto the ramps.
• The loading area must be clean and non-slip, use anti-
slip mats if necessary.
• When positioning the vehicle on the loading surface,
ensure that the center of gravity of the load is as low
as possible and in the longitudinal center line of the
transport vehicle if possible.
• The permitted total weight or the axle load of the trans-
port vehicle must not be exceeded during loading or
transportation.
• Place partial loads so as to ensure an even load on all
axles of the transport vehicle.
To Next Page
Loading...
