3 Safety
34
Operator’s Manual | 1190e | 1000441528 | 08/2022 | [en]
• Visually inspect to ensure that all attachment points
are not damaged or worn (e.g. no widening, no sharp
edges, no cracks).
• Have loads fastened and crane operators only guided
by experienced persons.
• The person guiding the crane operator must be within
sight or sound of him.
• Observe all movements of the vehicle and lifting gear.
• Secure the vehicle against unintentional movement.
• Raise the vehicle only after it is safely attached and
the signalman has given his approval.
• Use only the slinging points provided for fastening the
lifting gear (for example cables, belts).
• Do not attach the vehicle by twining the lifting gear (for
example cables, belts) around it.
• Ensure an even load distribution when fastening the
lifting gear.
• Ensure that no one is in, on or under the vehicle when
loading the vehicle.
• Observe the national regulations.
• Load the vehicle only in accordance with this oper-
ator’s manual to avoid damage to the vehicle.
• Do not raise a vehicle that is stuck or frozen onto the
ground, for example.
• Bear in mind the weather conditions (for example the
wind force).
3.8.3 Transporting
• For the safe transportation of the vehicle:
– The transport vehicle must have a sufficient bear-
ing load and loading surface.
– The maximum weight rating of the transport
vehicle must not be exceeded.
• Use only lifting and fastening gear certified by a test or
certification body, observe the inspection intervals. Ad-
here to the inspection intervals .
• Do not use any lifting and fastening gear that is dirty,
damaged or not of sufficient size.
• In order to secure the vehicle on the loading surface,
use only the fastening points provided for this purpose.
To Next Page
