15
28. Press a 1 1/2” Inner Cap (32) into the Leg
Lever (29).
Lubricate the 5/16” x 2 1/4” Bolt (33). Attach
the Leg Lever (29) to the Seat Frame (36)
with the 5/16” x 2 1/4” Bolt and a 5/16” Nylon
Locknut (3).
Insert the 3/8” x 2” Eyebolt (35) into the Leg
Lever (29) from the direction shown. Tighten
a 3/8” Nylon Locknut (21) with a 3/8” Flat
Washer (9) onto the Eyebolt.
29. Rest the Seat Frame (36) on the indicated pin
in the Front Upright (42). Attach the Seat
Frame to the Front Upright with a 5/16” x
2 3/4” Carriage Bolt (14) and the Seat Knob
(40).
30. Press two 3/4” Round Inner Caps (34) into
each 13 1/2” Pad Tube (28).
Insert one 13 1/2” Pad Tube (28) into the
Seat Frame (36). Slide a 6” Pad (30) onto
each end of the Pad Tube.
Insert the other 13 1/2” Pad Tube (28) into the
Leg Lever (29). Slide a 6” Foam Pad (30)
onto each end of the Pad
T
ube.
31. Press 1 1/2” Inner Caps (32) into the ends of
the Left VKR
Arm (79) and the Right VKR
Arm (80).
Attach the Left VKR Arm (79) and the Right
VKR
Arm (80) to the VKR
Upright (74) with
two 5/16” x 3” Bolts (75) and two 5/16” Nylon
Locknuts (3).
31
28
29
30
SEAT ASSEMBLY
VKR ASSEMBLY
36
3
33—Lubricate
35
29
9
21
32
42
40
36
36
34
30
34
29
74
79
32
32
3
75
80
30
28
14
Pin
To Next Page
Loading...
