Note: Assembly is divided into five stages: 1) frame assem-
bly, 2) press and butterfly arm assembly, 3) cable and pulley
assembly, 4) seat and backrest assembly, and 5) VKR
assembly. The hardware for each stage is packaged sepa-
rately. WAIT UNTIL YOU BEGIN EACH ASSEMBLY STAGE
TO OPEN THE PARTS BAG LABELED FOR THAT ASSEM-
BLY STAGE.
This chart is provided to help you identify the small parts used in assembly. Important: Some parts may
have been pre-assembled for shipping purposes. If you cannot find a part in the parts bags, check to
see if it has been pre-assembled. The number in parenthesis below each part refers to the key number of
the part. The second number refers to the quantity needed for assembly.
REMOVE THIS PART IDENTIFICATION CHART
FROM THE MANUAL
To Next Page
Loading...
