Weider Platinum XP600 - ADJUSTING THE RESISTANCE

ATTACHmNGTHEACCESSORmES
ToattachaShortHandHe(67)toahighpuHHey,first
attachthehighpuHHeytotheresistancesystem(see
ATTACHHNGTHEHHGHPULLEYSonpage13),Then,
attachtheShortHandHetotheShortCabHe(60)witha
CabHeCHip(64),
TheLongHandles(notshown)andtheAnkleStrap
(notshown)canbeattachedtothelongcable(not
shown)withCableCHips(64),AttachtheLegPress
Strap(notshown)to bothendsofthelongcable,orthe
LatBar(notshown)totheShortCables(60),withtwo
CableCHips,
ATTACHINGTHELEGLEVER
TousetheLegLever(32),attachthetwoendsofthe
LegLeverCable(62)totheendsofthelongcable(C)
withtwoCableClips(64),
DetachtheLegLeverCable(62)fromthelongcable
(C)whentheLegLever(32)isnotinuse,Storethe
endsoftheLegLeverCableonthehookunderthe
BenchRail(23),
ADJUSTINGTHERESISTANCE
Tochangetheresistancesetting,pressthe+/ -
switch on the Console (53), The display will show the
current resistance level setting, The resistance can be
increased up to 240 pounds,
Note: While the resistance setting is changing, the
motor wHHbe heard, To prevent damage to the
motor, do not pull any of the cables while the
resistance setting is changing.
Note: The resistance system uses progressive resist-
ance, As the resistance bar begins to bend, the
amount of resistance wHHincrease graduaHHy,As the
bar bends further, the resistance wHHincrease rapidHy,
6O
67
C
/
/
/
Hook
16