Weider Shape Glider - Page 9

MAINTENANCE AND STORAGE
Inspect and tighten all parts of the SHAPE GLIDER regularly.
The SHAPE GLIDER should be oiled every six months.
Apply a few drops of light multi-purpose oil in the loca-
tions shown at the right. Be sure to apply oil to both sides
of the SHAPE GLIDER.
Apply Oil
1
Apply Oil
The unique SHAPE GLIDER can be folded for easy stor-
age. Follow the steps below to fold the SHAPE GLIDER.
,
If the Handlebar Post (5) is in the Wheel Tube (9), the
Handlebar Post must be moved to the Pedal Frame
(6) before the SHAPE GLIDER can be folded. Press
the Spring Clip (32) and slide the Handlebar Post out
of the Wheel Tube. Press the Spring Clip again and
insert the Handlebar Post into Pedal Frame (6). Make
sure that the Spring Clip snaps into the indicated hole
in the Pedal Frame.
2. Firmly hold the handlebar (not shown) and lift the Link
Arm (10) off the Butterfly Bushing (25) on the Pedal
Frame (6). Lower the Seat (3).
,
Refer to drawing 3a. Firmly hold the handlebar (not
shown) to prevent it from falling. Remove the Lock
Pin (16) From the Upright Frame (8) and the Base
(11).
Refer to drawing 3b. Lower the Handlebar Frame (8).
Insert the Lock Pin (16) into the tube under the Base
(11).
To set up the SHAPE GLIDER for use, refer to ASSEM-
BLY on page 5.
Hole
6
. 3
25
3b
8
16
9