19
36. Wrap the Cable (131) over a Small Pulley (59).
Attach the Small Pulley and a Cable Trap (76) to
the Rear Frame (31) with an M10 x 45mm Bolt
(104) and an M10 Nylon Locknut (94).
37. Wrap the Cable (131) under a Small Pulley (59).
Attach the Small Pulley, two Half Guards (62),
and a Cable Trap (76) to the “U” Bracket (57) with
an M10 x 50mm Bolt (111) and an M10 Nylon
Locknut (94).
Make sure the Half Guards are
oriented as shown.
36
37
31
94
76
59
104
131
59
111
62
131
76
57
94
62
35. Position the Bottom Plate (65) and the Top Plate
(64) around the Cable (131) as shown. Attach the
B
ottom and Top Plates to the Right Front Frame
(33) with two M4 x 16mm Self-tapping Screws
(
102).
3
5
102
1
31
102
64
65
3
3
To Next Page
Loading...
Need help?
General
