IE-CS(T)-2TX-xRS232/485 IP Serial LIB
6-14
COM Mapping
Windows Administration Suite comes with Windows 95/98/ME/NT/2000/XP/7 Real COM drivers. After you
install S/E-Converter Administrator, there are two ways to set up the IE-CS(T)-2TX-xRS232/485 serial port as
your host’s remote COM port.
The first way is with On-line COM Mapping. On-line COM Mapping will check to make sure that the
IE-CS(T)-2TX-xRS232/485 is connected correctly to the network and then install the driver on the host
computer.
The second way is with Off-line COM Installation, without first connecting the IE-CS(T)-2TX-xRS232/485 to
the network. Off-line COM Mapping can decrease the system integrator’s effort by solving different field
problems. Via off-line installation, users can first process software installation for the host, and then install the
IE-CS(T)-2TX-xRS232/485 to different fields.
Use the following procedure to map COM ports:
1. On-line COM Mapping:
Connect IE-CS(T)-2TX-xRS232/485 to the network Set IE-CS(T)-2TX-xRS232/485to the proper IP
address Map COMs to your host Apply Change.
2. Off-line COM Mapping:
Map COMs to your host Apply Change Connect the IE-CS(T)-2TX-xRS232/485 to the network
Configure IE-CS(T)-2TX-xRS232/485’s IP address.
On-line COM Mapping
1. Broadcast Search for IE-CS(T)-2TX-xRS232/485s on the network.
2. Select the COM Mapping function group.
To Next Page
Loading...