Weiser Powerbolt 1 Installation And User Guide

21/8"
54 mm
1"
25 mm
A
or
or
1 / 4
Required tools
Ruler4 AA Batteries
Hammer
Wood
block
Phillips screwdriver
Outils additionnels (en fonction de l’application)
ENGLISH
67532
Rev 02
SED9400
Installation and User Guide
Weiser
Technical Support
1-800-501-9471
www.weiserlock.com
If drilling a new door, use the supplied template and the complete door drilling
instructions available at www.kwikset.com/doorprep
backset
Measure to conirm that the hole in
the door is 21/8" (54 mm).
Measure to conirm that the backset is
either 23/8" or 23/4" (60 or 70 mm).
23/8" or 23/4"
60 or 70 mm
13/8" or 13/4"
35 mm or 44 mm
Measure to conirm that the hole in
the door edge is 1" (25 mm).
Measure to conirm that the
door is either 13/8" or 13/4"
(35 mm or 44 mm) thick.
A B C D
Latch
Exterior Assembly
Interior Cover
Strike
Parts in the box
Mounting Plate Interior
Assembly
Align tabs with
holes in collar.
Install latch
in door
with wood
block and
hammer.
Ensure collar
snaps into place.
Pull collar to
test for tight it.
Make sure
slotted hole
is at bottom
of latch.
A B C
D
Is the door edge chiseled?
Hold the latch in front of the door hole, with the
latch face lush against the door edge.
Make sure the latch bolt is fully retracted
(in the unlocked position).
Install strike on the door frame.
180°
unlocked
door frame
Make sure hole in door frame is drilled a
minimum of 1” (25 mm) deep.
not
chiseled
chiseled
Install latch in door
with supplied screws.
If needed, change
latch plate
Use a lathead screwdriver to
lift tabs on collar of rectangular
face to remove it from latch.
Install drive-in collar.
Is the slotted hole centered in the door hole?
YES NO
slotted hole
is centered
slotted hole is
NOT centered
No adjustment is
required. Proceed
to next step.
Rotate latch
face as shown to
extend latch.
Make sure
slotted hole is at
bottom of latch.
Yes NO
Latch and
Strike Screws
TailpieceInterior Assembly
Screws
Mounting Plate Screws
For 13/4"
thick doors
For 13/8"
thick doors
G
E
C
A
A2 B
D
F
C
A
H (x2)
H (x2)
B
A A2
A
A
H
J
K
L
M
1
Prepare the door and check dimensions
2
Install the latch and strike

Weiser Powerbolt 1 Specifications

General

Type	Electronic Deadbolt
Keypad	Yes
Battery	4 AA Batteries
Bolt Throw	1"
Pack Quantity	1
Backset	2-3/4"
Finish	Satin Nickel
Handing	Self-Handing
Keyway	N/A (Keyless)