A
P (2x)
C
Levers
Ruler Phillips head screwdriver
N P
actual
size
26298
27526 64156
22044
P
Z
U V
T
N
1 / 4
66077001 Rev 01
GED1455
ZWave® Plus
Installation and User Guide
Weiser
Technical Support
1-800-501-9471
www.weiserlock.com
Parts in the box
Latch
Strike
Keys
Batteries
Spindle
Exterior
Assembly
Mounting
Plate
Fasteners
SmartKey
Tool
Interior
Assembly
If drilling a new door, use the supplied template and the complete
door drilling instructions available at www.weiserlock.com/doorprep.
backset
Measure to conirm that the hole in
the door is 54 mm (2 1/8 in).
*If you are installing this lever below
an existing lock or you plan to install a
lock above this lever, make sure that the
distance between holes is at least 165 mm
(6 1/2 in).
Measure to conirm that the backset is
either 60 or 70 mm (2 3/8 or 2 3/4 in).
60 or 70 mm
2 3/8 or 2 3/4 in
See
note
below*
35 – 44 mm
1 3/8 – 1 3/4 in
Measure to conirm that the hole in
the door edge is 25 mm (1 in).
Measure to conirm that the door is
between 35 and 44 mm (1 3/8 and
1 3/4 in) thick.
A
A C
B
D
E
B C D
Is the semi-circular hole of the latch centred in
the door hole?
Is the door edge chiselled?
Install strike on the door frame.
Hold the latch in front of the door hole, with the latch
face lush against the door edge.
Adjust the latch face (if needed).
lush
25 mm
1 in
YES NO
No adjustment is required.
Proceed to next step.
Move the pin to
extend the latch.
door frame
ENGLISH
Required tools
Hammer Wood block
Additional Tools (depending on application)
54 mm
2 1/8 in
For doors without chiselled edge
For square corners
Proceed to step 2D.
1. Remove square corner faceplate.
1. Remove plates.
Ensure A2
snaps into
place.
For round corners
2. Install round corner faceplate.
2. Install drive-in collar.
YES NO
slant of latch
bolt faces
door frame
slant of latch
bolt faces
door frame
wood block
J
A A2 A3
C
M
K
L
F
G
F2E
H
Y2
Y1
A
A
A
A2
N (2x)
A3
or
or
chiselled
not
chiselled
1
Prepare the door and check dimensions
2
Install the latch and strike
To Next Page
General
