Why does my Weiser lock keypad flash red 10 times?
If your Weiser lock keypad flashes red 10 times and beeps 10 times, this indicates a low battery. You should replace the batteries as soon as possible.
What to do if my Weiser lock beeps 2 times?
If your Weiser lock beeps 2 times, it means there was a programming timeout. You should attempt the programming procedure again, ensuring that you do not pause for more than 5 seconds during the process.
What to do if my Weiser lock keypad flashes red 15 times?
If the Weiser lock keypad flashes red 15 times and beeps 15 times, it signifies that three incorrect codes were entered within one minute. The suggested solution is to re-enter the code after a 60-second keypad lockout.
Why is my Weiser lock keypad flashing red 3 times?
If your Weiser lock keypad flashes red 3 times and beeps 3 times, it could be due to one incorrect code being entered, or because no user code has been programmed. Try re-entering the code, attempt the programming procedure again or program at least one user code.
How to fix Weiser lock when keypad flashes red once?
If the Weiser lock keypad flashes red once and beeps once, it means the door jammed while attempting to lock. Manually re-lock the door. If needed, reposition the strike.
General| Backlit Keypad | Yes |
|---|---|
| Backup Key | Yes |
| Connectivity | No connectivity |
| Batteries | 4 AA |
| Warranty | Limited Lifetime |
| ANSI Grade | 2 |
| Battery Life | Approximately 1 year |
| Auto-Lock | Yes |
| Finish | Satin Nickel |
| Compatibility | Standard door prep |
| Type | Electronic Deadbolt |
Lists necessary tools and identifies all package components for installation.
Guides on checking door dimensions and hole sizes for proper lock installation.
Step-by-step instructions for installing the latch, strike, spindle, and exterior components.
Guides on mounting the interior assembly, battery pack, and lever handles.
How to test and adjust the latch for proper door closing and strike alignment.
Procedures for adding, managing, and testing user codes for access.
Information on using a mastercode for enhanced security and managing user access.
Step-by-step guides for locking and unlocking the door using the keypad or codes.
Instructions for re-keying the lock to match existing keys and installing the battery cover.
Explains lock components, system alerts, their reasons, solutions, and LED status indicators.
Details switch functions, troubleshooting, user code deletion, battery replacement, and factory reset.
Procedures for performing a factory reset and important safety precautions for lock usage.
To Next Page
