COMPLIANCE AND WARRANTY INFORMATION
• This appliance must be installed by a registered electrician in accordance with the relevant electrical
wiring rules and regulations and a COC is required for a warranty claim.
• Heat Transfer units are Not for use with a heat pump
• Do not cover the fan unit with any insulation material
• Do not completely close off adjustable outlet vents
• Always install this product with the supplied controller
• Weiss Limited reserves the right to alter designs and specifications without notice
• Incorrect wiring or installation is not covered by warranty
• Full Warranty information is available on our web site: https://www.weiss.co.nz/warranty
QUESTIONS AND ANSWERS
Can I place the controller in a different room from the fireplace/heat source?
No. The controller must be mounted in the same room as your heat source. Make sure that the controller is
in a position where it can easily detect changes in the room temperature from your heat source, e.g. 2-4
metres away from the heat source. Do not place the controller in the hallway or near the doorway, around
a corner from the heat source, or far away (>6 metres) from the heat source in a large room.
How far away from the heat source should I place the fan?
You should keep at least 1.5 metres of distance between the heat source extraction point and the fan.
However, the recommended distance between the extraction point and the fan is 3 metres.
IMPORTANT NOTES
Troubleshooting: The control panel has built-in error detection and may display the following faults:
Sensor fault will display and“E1”and“E2”.
E1: Sensor short circuit alarm
E2: Sensor open circuit alarm
When temperature higher than 55℃ displays “HI”
When temperature lower than 0℃ displays “LO”
To Previous Page
Loading...
