OWNERS MANUAL FOR WEISS MEDEA+ D/A CONVERTER
Page: 30 Date: 02/11 /dw
Mac:
0. Mount the WeissFirewire.dmg diskimage by double clicking it
1. From the mounted drive double click WeissFirewire-3.3.3.3586.pkg (the version numbers can
be different of course)
2. Click "Continue"
3. Select the drive (usually you leave it at the defaults)
4. Click "Continue"
5. Click "Upgrade" or "Install"
6. You'll be asked to login as administrator
7. Confirm "Continue Installation" when warned that the computer requires a reboot after install.
8. Click Restart
After installation of the software connect the MEDEA+ to the computer. Make sure to plug in the
Firewire cable in the proper orientation! If the connector is plugged in reversed the MEDEA+
firewire interface can be distroyed because of the bus power on the Firewire bus.
The MEDEA+ should now be recognized automatically. In Windows tell the installation window
that you do not want to check the Microsoft website for drivers and then let the drivers be
installed automatically. Ignore warnings concerning “Windows Logo Test” and continue the
installation until completed. You will be asked to install drivers for "Weiss Engineering Ltd. --
Firewire Unit--" and "Weiss Firewire IO MIDI". There will be two passes of installation, which is
normal.
Software setup
The connected MEDEA+ device can be controlled through the “Weiss Firewire I/O” Control Panel.
Windows:
The control panel can be accessed by clicking on the “Weiss Firewire IO” icon on the desktop.
To Next Page
Loading...
