OWNERS MANUAL FOR WEISS MEDEA+ D/A CONVERTER
Page: 31 Date: 02/11 /dw
Device Settings / General: The device settings should be pretty self explanatory.
Device Settings / Firmware Loader: Allows to upload new firmware to the MEDEA+. Not used for
normal operation.
Global Settings / Bus:
Master: Is the device which is sync master on the virtual bus in case multiple devices
(“MEDEA+s”) are connected.
Sync Source: The clock to which the MEDEA+ should sync to. Usually this is the MEDEA+’s
internal clock generator.
Sampling Rate: The sampling rate of the device when internally clocked.
Buffer Size: Larger buffer sizes increase robustness against dropouts, lower buffer sizes provide
low latency.
Operation Mode: determines the stability of the system. Try other modes if there are clicks in the
music.
Global Settings / WDM: Enables the WDM driver.
Global Settings / DPC: Determines your computers performance and recommends a operation
mode.
Global Settings / System: Some utilities to determine the chipset in your computer and to get
information on the sup-ported chipset. Required for debugging if prob-lems with the Firewire
connection are encoun-tered.
Global Settings / Info: Information about the driver version.
Mac OSX:
Configure the MEDEA+ via the “Audio MIDI Setup” (Applications > Utilities) and the “Weiss
Firewire Control Panel” (Applications).
Device Settings / General: The device settings should be pretty self explanatory.
To Next Page
Loading...
