www.welbilt.com 800-225-9916 8
All wiring must comply with local and national codes. Wiring must be performed only
by a refrigeration technician or certified electrician. Failure to follow these guidelines
Tout le câblage doit être conforme aux codes locaux et nationaux. Le
câblage ne doit être effectué que par un technicien en réfrigération ou un
électricien agréé. Le non-respect de ces consignes peut entraîner des
blessures!
Check all wiring connections, including factory terminals, before operation.
Connections can become loose during shipment and installation.
Vérifier toutes les connexions de câblage, y compris les bornes installées
en usine, avant de faire fonctionner l’appareil. Les connexions peuvent
devenir lâches pendant l’expédition et l’installation.
Piping
General Requirements:
All refrigeration piping and components are to be installed in accordance with applicable
local and national codes and in conformance with industry refrigeration guidelines to
ensure proper operation of the refrigeration system. Only refrigeration grade copper
tubing should be used. Long radius elbows should be used. Short radius elbows have
points of excessive stress concentration and are subject to breaking at these points, do
not use short radius elbows. Suction lines must be insulated with a minimum ¾” thick
insulation tubing to reduce heat pick-up.
To Next Page
Loading...
