Welch Allyn LS-135 - Assembly Instructions for Ls-135 & Ls-150

ASSEMBLY INSTRUCTIONS FOR LS-135 & LS-150
Required tools for assembly: Phillips #2 or #3 screwdriver.
1. Remove all items from the
shipping carton. Check for
damage or missing
components. Refer to
photo 1 and table 1. Notify
Welch Allyn, or your
nearest Service Center of
any damage or missing
parts using the appropriate
phone number listed on
page 13.
2. With the Base Assembly
placed on a suitable
surface (5' x 2' table or
carpeted floor), identify the
flange end of the pole.
Feed the electrical
connector through the
center hole of the base,
taking care not to pull the
twist tie holding the
electrical connector at the
other end of the pole into
the pole. Refer to photo 2.
No.
Description
1
Base Assembly
2 Luminaire-Flexible Arm Assembly
3 Pole Assembly
4
Parts Kit
• Base Cover Plate
• Screw 1/4-20 x 1" Phillips
•1/4" External Lockwasher
3