Welch Allyn LS-135 - Lamp Replacement.8

LAMP REPLACEMENT
A
Disconnect power cord from electrical outlet prior to replacement.
^ Allow lamp to cool 10 minutes prior to replacement.
1. Exposing the Lamp (Refer to photo 1)
• Turn power switch to the off (" H ") position and unplug power
cord from outlet.
• Rotate Light Assembly ® so that the lamp points up (towards
ceiling).
• Completely loosen screw in Lamp Housing ® and lift to expose
the Lamp ©.
2. Freeing the Lamp and Lamp Socket (Refer to photo 2)
• Release the Lamp Retaining Wire ® from the Lamp Housing ® by
pushing on wire "ears" towards Lamp Socket and swing out as
shown to free the Lamp © and Lamp Socket ®.
3. Removing the Lamp Socket (Refer to photos 3 and 4)
• Hold the Lamp © by its outer rim. Grasp the white sides of the
Lamp Socket ® as shown, pull on the Lamp Socket ® while
rocking it slightly to remove it from the Lamp ©. Do not pull on
Lamp Socket Wires ©.
8