Page 11
MACHINE SET UP - MMA / TIG / MIG / MIG ALUMINIUM
AND MOG WELDING (cont.)
MIG / MAG (continued from previous page)
4) Connect the tube of the gas cylinder on the rear panel of the machine. The gas used is
generally a mixture of Argon and C02 (MIX), otherwise only C02. It is recommended to use
the Argon for the welding of the aluminum.
5) Open the side mantle, place the wire spool on the paddle wheel (if it there isn’t) and insert
the wire in the wire feeder.
WARNING: The roller has two grooves: changing the roller, you can choose the appropriate
groove according to the diameter of the wire that you want to use. When changing the
diameter of the wire is necessary to change both the roller and the contact tip (end part of
the torch from which one you can see the wire coming out). Unscrew the gas nozzle and the
contact tip to facilitate the passage of the wire.
6) Unroll the torch cable so as to prevent the thread from curling.
7) Stop the roller.
8) Connect the power supply plug to the power outlet and turn on the welding machine.
9) Select MIG welding, press the wire feed button (Figure 3, the button is near the wire
feeder) until the wire comes out of the torch, close the side mantle.
MIG WITHOUT GAS (MOG)
1) Turn o the welding machine.
2) Open the side mantle, mount the ux cored wire coil (see “MIG/MAG” use), choose the
roller for the ux cored wire.
3) Connect the plug of the work clamp to the Positive socket, “+”, and the plug of the cable
GAS I NO GAS to the Negative socket, “-”.
4) Connect the power supply plug to the power outlet and turn on the welding machine.
5) Select the MIG welding, press the wire feed button until the wire comes out of the torch,
close the side mantle.
MIG ALUMINIUM
For MIG welding with aluminum wire it is necessary to set the machine with the KIT FOR
ALUMINIUM WELDING. The kit (not included with the machine) includes: Teon sheath,
nipple, o-ring. Proceed as presented in section “MIG/MAG” use. In this case, use pure argon.
To Next Page
Loading...
