Weller WT2010M - Critical Safety Warnings; Electrical Shock Hazard; Burn and Fire Hazards

19
Read these instructions and the safety
guidelines carefully before starting up the unit
and starting work.
Failuretoobservethesafetyregulationsresultsinariskto
life and limb.
Keep these instructions in a place that is accessible to all
users. Please adhere to the operating instructions of the
connected devices.
Safety information
Thisappliancecanbeusedbychild-
renagedfrom8yearsandaboveand
personswithreducedphysical,sensory
or mental capabilities or lack of experi-
enceandknowledgeiftheyhavebeen
given supervision or instruction concer-
ninguseoftheapplianceinasafeway
and understand the hazards involved.
Childrenshallnotplaywiththeappli-
ance.
Cleaning and user maintenance shall
notbemadebychildrenwithoutsuper-
vision.
Keep other persons well away from your workplace.
The work area is out of bounds for children and unauthorised
persons. Never allow other persons to touch the soldering
tool or cable.
WARNING
Electrical shock
Connecting the control unit incorrectly poses a risk of
injury due to electric shock and can damage the device.
• Carefullyreadtheattachedsafetyinformation,thesafety
informationaccompanyingtheseoperatinginstructionsas
wellastheoperatinginstructionsforyourcontrolunitbefore
putting the control unit into operation and observe the
safetyprecautionsspeciedtherein.
• OnlyconnectWELLERtools.
If the device is faulty, active electrical conductors may be
bare or the PE conductor may not be functional.
• RepairsmustalwaysbereferredtoaWeller-trained
specialist.
• Iftheelectricaltool‘spowersupplycordisdamaged,itmust
bereplacedwithaspeciallyprefabricatedpowersupply
cord available through the customer service organisation.
Protect yourself against electric shocks. The handles on
soldering tools with an antistatic design are conductive.
• Avoid touching earthed objects such as pipes, heaters,
cookers and refrigerators.
• Do not use the soldering tool in a damp or wet environment.
• Neverworkonvoltage-carryingparts.
WARNING
Risk of burns
Risk of burns from the soldering tool while the control
unit is operating. Tools may still be hot long after they
have been switched off.
• Alwaysplacethesolderingtoolinthesafetyrestwhilenot
inuse.Makesurethesafetyholderisstable.
• Onlyreplacesoldertipswhencold
Risk of burning through liquid solder. Protect yourself
against solder splashes.
• Wearappropriateprotectiveclothingtoprotectyourself
againstburns.Protectyoureyesbywearingeye
protection.
• Whenworkingwithadhesives,specialattentionmustbe
paidtothewarninginformationprovidedbytheadhesive
manufacturer.
WARNING
Fire hazard
Covering the soldering iron or the safety holder poses
a re hazard. Always keep objects well away from the
soldering iron and safety holder.
• Alwayskeepobjectswellawayfromthesolderingiron
andsafetyholder.
• Keepallcombustibleobjects,liquidsorgaseswellaway
from the hot soldering tool.
EN
ENGLISH