Need help?Do you have a question about the Wellis CITYLIFE and is the answer not in the manual?
General| Seats | 3 persons |
|---|---|
| Control System | Wellis Smart Touch |
| Power requirements | 1 × 16A 230V/50Hz |
| Insulation | Full foam insulation |
| Lighting | 16 LED lights |
Essential precautions for spa operation and safety.
Guidelines for safe water temperature and usage precautions.
Specific safety advice for plug-and-play spa installations.
Controls for spa functions: pumps, light, and temperature.
Diverters and air regulators control water flow and air mix.
Description of jet sizes, types, and directional control.
Requirements for electrical setup before hot tub installation.
Choosing a suitable location and ensuring accessibility for maintenance.
Proper procedures for filling the spa with water.
Procedures for cleaning and replacing spa filter cartridges.
Steps to prepare the spa for winter to prevent damage from freezing.
Instructions for draining spa water according to environmental standards.
Using Spa Cleaner for pipe and pool cleaning.
Balancing alkalinity to maintain stable pH levels.
Lowering spa water pH using pH Minus.
Weekly cleaning of filters for crystal clear water.
Diagrams showing jet activation patterns for Malaga Life spa.
Diagrams showing jet activation patterns for Prague Life spa.
Overview of the in.k500 keypad layout and button functions.
Details on operating pumps, lights, and temperature adjustments.
Guide to setting clock, cycles, economy mode, and temperature units.
Troubleshooting common spa errors and their meanings.
Selecting heating or cooling modes before setting temperature.
Step-by-step guide for setting the heat pump to heating mode.
Checking status values and adjusting advanced heat pump settings.
Visual guide to identifying all components of the Smart Step accessory.
How ozone disinfection works with filtration and circulation systems.
Selecting heat modes (DIS, INT, EXT, BOTH, SMART) for the in.grid module.
Explanation of freeze protection features in EXT mode.
Connecting spa to internet via in.touch 2 for remote control.
Using the app for control, programming, and receiving spa status notifications.
Installing the Home Transmitter near the router for connectivity.
Procedure for pairing spa and home transmitters if replacement is needed.
Instructions for downloading the Wellis Spa Control app for iOS and Android.
Controlling the spa remotely using the internet connection.
Adjusting the spa's temperature set point using the app's control bar.
Customizing color zones and lighting effects with in.mix 300.
Setting up filtration and heating schedules for different water care modes.
Accessing app settings like network, units, and name.
Using spa's internal heater only.
Using external heating system for energy savings.
Activating both internal and external heaters.
Using external heater with internal support.
Wiring configurations for 1, 2, and 3-phase connections.
Adjusting low-level configuration like phases and heat pump current.
Procedure for powering up the spa and verifying breaker settings.
Troubleshooting steps for a spa that is not operating.
Common causes and solutions for heater malfunction.
Troubleshooting steps for cloudy or dirty spa water.
Troubleshooting low water flow from spa jets.
To Next Page
