REMINDER MESSAGES
General maintenance helps
Reminder Messages can be suppressed by using the PREF Menu.
Reminder Messages can be chosen individually by the Manufacturer. They may be disabled entirely, or
there may be a limited number of reminders on a specific model.
The frequency of each reminder (i.e. 7 days) can be specifi ed by the Manufacturer.
Press a Temperature button to reset a displayed reminder message.
Appears on a regular schedule, e.g. every 7 days.
Check pH with a test kit and adjust pH with the appropriate chemicals.
Alternates with temperature or normal display.
Appears on a regular schedule, e.g. every 7 days.
Check sanitizer level and other water chemistry with a test kit and adjust with the appropriate
chemicals.
Alternates with temperature or normal display.
Appears on a regular schedule, e.g. every 30 days.
Clean the filter media as instructed by the manufacturer.
Alternates with temperature or normal display.
Appears on a regular schedule, e.g. every 30 days.
The Ground Fault Circuit Interrupter (GFCI) or Residual Current Device (RCD) is an important safety
device and must be tested on a regular basis to verify its reliability.
Every user should be trained to safely test the GFCI or RCD associated with the hot tub installation.
A GFCI or RCD will have a TEST and RESET button on it that allows a user to verify proper function.
Alternates with temperature or normal display.
Warning:
If freezing conditions exist, a GFCI or RCD should be reset immediately or spa damage could result.
The end user should always trained to test and reset the GFCI or RCD on a regular basis.
To Next Page
Loading...
