19 of 20 Wellness Supply Group V002
G. User Setting Programs:
Program-13 to Program-16 are the user-setting programs. Users are free to edit the values
in the order of TIME, COUNT, CALORIES, AGE and the level of loading in 10 intervals.
The values and profiles will be stored in the memory after setup. After pressing
“START/STOP” key to exercise, please also apply the heart rate detector appropriately.
Users may also change the ongoing loading in each interval by pressing ▲ or ▼ key, and
they will not change the level of loading stored in the memory. With the input of age, the
computer may suggest a target heart rate to exercise. The suggested heart rate is
85%(220 – age). So, if the heart rate detected equals to or greater than the TARGET H.R.,
the value of HEART RATE will keep flashing. Please note that it is a warning for users
to slow down or to lower the level of loading.
H. Watt Independent Program:
Program 17 is a Watt Independent Program. Press “ENTER” key to select the values of
TIME, COUNT, WATT, and AGE. Then, press ▲ or ▼ key to adjust the values. After
pressing “START/STOP” key to exercise, please also apply the heart rate detector
appropriately. During the exercise, the level of loading is not adjustable. In this program,
computer will adjust the level of loading according to the value of WATT setup. For
example, the level of loading may increase while the speed is too slow. Also, the level of
loading may decrease while the speed is too fast. As a result, the calculated value of
WATT will close to the value of WATT setup by users. With the input of age, the computer
may suggest a target heart rate to exercise. The suggested heart rate is 85%(220 – age).
So, if the heart rate detected equals to or greater than the TARGET H.R., the value of
HEART RATE will keep flashing. Please note that it is a warning for users to speed
down or to lower the level of loading.
I. Pulse Recovery:
It is a function to check the condition of pulse recovery that is scaled from 1.0 to 6.0 while
1.0 means the best and 6.0 means the worst and the increment is 0.1. In order to get rated
correctly, users must test it right after the workout finished by pressing “PULSE” key and
then stop exercising. After the key is pressed, please also apply the heart rate detector
appropriately. The test will last for 1 minute and the result will show in the display.
6. Maintenance
i) Keep the product clean and free from dust, dirt and foreign substances.
ii) Inspect regularly for any damage and general ware and tear.
iii) Replace worn or damaged parts immediately.
iv) Repair of product should be carried out by a certified technician or manufacturing
company.
v) Do not repair the device outside of manufacturers recommendations.
7. Storage and Moving
i) Keep product in a clean, dry environment.
ii) Should be kept on a flat surface.
iii) Never drop or roughly handle the product.
To Next Page
Loading...