Wells M4200 - Enabling Scratch Biscuit Button (#6)

PROGRAMMING INSTRUCTIONS (continued)
18
IMPORTANT: This oven is pre-programmed from the factory and does not require
programming adjustments under normal circumstances. Any programming
changes must be performed by qualified persons only.
ENABLING SCRATCH BISCUIT BUTTON (#6)
ACTION DISPLAY WILL READ
1. Enter programming mode, press and
hold PROG button for 5 seconds CAL TEMP NO
2. Press PROG button until EDIT MENU is
reached EDIT MENU ITEM NO
3. Press #2 or #8 button for YES EDIT MENU ITEM YES
4. Press PROG button PASSWORD 0000
See page 22 for password and recommended oven settings
5. Press PROG button to select daypart. SELECT DAYPART # 1
NOTE: Only daypart #1 is activated
6. Press PROG button SEL>
7. Press # 6 button to select SCRATCH BISCUITS SCRATCH BISCUITS
8. Press PROG button to enable any name change S
CRATCH BISCUITS
9. Press PROG button ENABLE NO
10. Press #2 button to enable SCRATCH BISCUIT
Button ENABLE YES
11. Press PROG button CANCEL A/M MANUAL
(Should always be Manual)
12. Continue pressing PROG button until beep
sounds, indicating new information was saved UPDATING MENU ITEM
13. Press START button OVEN READY
Enabling Scratch Biscuit button (#6) is now complete.
IMPORTANT: DO NOT CHANGE FACTOR VALUES OR FACTOR TIMES FOR EXISTING MENU
ITEMS
NOTE: Cannot go into edit or view program mode when cooling timer is activated or when in
a bake cycle.