Wells MOD-400 - User Manual

Questions and Answers

K
Katrina Wilson MDJul 31, 2025
What to do if my Wells MOD-400 trips the circuit breaker?
- B
  brittney45Aug 1, 2025
  If your Wells Food Warmer is tripping the circuit breaker, there might be a few reasons. One potential cause is wet insulation. Check the flange-to-counter seal to ensure it's intact. If not, reseal it with food-grade silicone sealant. Another cause might be a pan leaking or other internal damage, in which case you should contact your Authorized Wells Service Agency for repairs. It is also possible that there is some other internal damage and you should contact your Authorized Wells Service Agency for repairs.
R
ryan44Aug 8, 2025
What to do if my Wells Food Warmer has no power?
- E
  Edward HughesAug 8, 2025
  If your Wells Food Warmer has no power, the first thing you should check is the circuit breaker. If it's off or tripped, reset it to restore power.
H
Hannah GonzalezAug 15, 2025
Why is my Wells Food Warmer slow to heat up?
- D
  daniel99Aug 15, 2025
  If your Wells Food Warmer is heating up slowly, there could be a couple of reasons. Mineral deposits on the pan acting as an insulator could be the reason. Try cleaning the pans with a delime cleaner. Also, verify that the supply voltage matches the voltage on the warmer's nameplate, as being wired to the wrong voltage can cause slow heating.
J
Jared AllenAug 23, 2025
What to do if my drain-equipped Wells MOD-400 will not hold water?
- A
  Amanda GarciaAug 23, 2025
  If your drain-equipped Wells Food Warmer isn't holding water, first check the drain valve to ensure it's fully closed and free of any debris. If the drain valve is damaged or the pans are leaking, contact your Authorized Wells Service Agency for repairs.