How to Use
05
13
UV LED
A UV-C LED is installed on the lower part of the ice tank. It sanitizes
the melt water to provide you with more hygienic ice.
ECO Mode
Once the ice level is full, the unit will automatically turn on ECO mode.
The ECO mode saves energy by stopping the ice making operation (for
maximum of 6 hours). The machine can still be used to dispense ice
and water while ECO mode is on.
How to Assemble the Water Tray
Push the water tray onto the unit until you hear a "click" sound.
*This machine has an audible ‘beep’ indictor when the water or
ice is dispensed. To turn off the beep sound, simultaneously
press and hold for 5 seconds both the HOT WATER and AMBIENT
WATER select buttons until all LED indicators flash 5 times.
To enable the beep, follow the same process.
Ice Dispense Chute Cleaning Method
1. Pull down the ice dispense chute to remove it from the unit.
2. After cleaning, return the chute back to its original location.
3. Insert tab #1 into the hole and push the chute upward. Make
sure the front three tabs (#2) are properly locked into the unit.
To Next Page
Loading...
