3. After removing the WATER TRAY, remove the TOP COVER & FRONT
COVER by loosening the fixing screws. (Ice-making operation will be
halted.) (Be careful of SCREW loss when opening the product.)
4. Pay attention to the wire while placing the TOP COVER & FRONT
COVER to the side.
5. Connect the drain hoses to the two DRAIN VALVES,(located at the
bottom of the front side), and then proceed to drain completely.
Once completed, remove the drain hoses. (The hot water intake
operation must be performed after cleaning.)
6. Remove the ICE BIN COVER by loosening the fixing screws, and then
disassemble the 2 AUGERS by pulling upward. (During removal &
reassembling, be careful not to lose the CAPS on the AUGERS and
the screws.) (When assembling the auger, pay attention to the
shape of the joint.)
7. Remove the ICE BASKET from the unit
How to Clean (cont.)
06
16
Evaporator Cleaning
Descaling Operation
Note: This cleaning process must be followed annually or every six
months depending on unit condition.
1. Mix 100 ml (3.4 oz) of cleaning fluid with 2 liters (67.6 oz) of
pre-prepared clean water, and pour slowly into the WATER
RESERVOIR. Th is will also fill the EVAPORATOR with cleaning solu
tion. Please be careful not to overflow the tank.
If you put more quantity of the clean water than those indicated
above, it may affect the product operation and performance.
Pour the cleaning fluid and clean water slowly so that it does not enter
to the Air Filter Connection port or over flow.
2. Wait 30 minutes to remove the scale. While waiting, wash the
detached ICE BASKET thoroughly with clean water.
3. Connect the drain hoses to the two DRAIN VALVES, located at the
bottom of the front side, and drain once more. Once completed,
remove the drain hoses.
4. Slowly pour the remaining 2 liters (67.6 oz) of pre-prepared clean
water into the WATER RESERVOIR. Connect the drain hoses to the
two DRAIN VALVES, (located at the bottom of the frontside), and
drain once more. Once completed, remove the drain hoses.
To Next Page
Loading...
