13
1. The ice machine must be installed indoors
2. Check water pressure, if over 70 psi, add a pressure regulator.
3. Place the ice machine so that it has five inches of clearance at the sides and rear of the unit,
so it has proper ventilation.
4. Unit will need to be sanitized.
a. Remove top and front panels
b. Open ice bin and water reservoir
c. Remove the augers and divider from the ice bin
d. Using a 1:4 ratio of hydrogen peroxide to water in a bottle, spray all surfaces inside
the ice bin, augers, diver and water reservoir.
e. Let solution sit for 5 minutes and wipe clean.
f. Spray small amount back into the reservoir and ice bin
g. Repeat steps c through e on the reservoir and ice bin lids.
5. This ice machine only requires a drain on the RO system.
6. Filters should be located under the sink.
7. The RO system filters must be flushed. See the preventive maintenance section for this process.
8. Note: this unit will require a RO storage tank. It is recommended the tank is full of water before the
installation so you will not have to wait for the RO to fill the unit and RO tank.
9. Fill hot tank
a. Select hot
b. Hold the dispense button until water is dispensed
c. Turn on hot tank by pressing the switch in the back of the unit.
INSTALLATION
Ice Bin
Water
Reservoir
Divider Auger
To Next Page
Loading...