WELTECH BW-2050 - Weigher Calibration Procedures; Calibrating the Weighing Unit; Taring the Shackle; Weigher Setup Options

CALIBRATION
The BW‐2050 is calibrated by Weltech before it leaves the factory.
Should you need to calibrate the weigher or set a fixed tare weight if
using a shackle then follow the instrucons below.
TOCALIBRATETHEWEIGHER
Have the weigher switched off with no shackle on. Hold down the CAL
key and turn on the weigher. When WELTECHSETUPis displayed
release the CAL key. The display will show CALIBRATION with 5.000 KGS
flashing below. You can adjust the calibraon weight up and down using
the INC and DEC keys to set the calibraon weight to the exact weight of
your calibraon weight. Press the ENTER key once the weight is set. The
display will show CALIBRATENOW?[SETUP]=YES. Press the SETUP key
and the display will flash up CALIBRATINGZEROand then the display
will show PLACETHEWEIGHT. Hang on your calibraon weight and the
display will show CALIBRATIONSCALINGand then SAVINGNEW
SETTINGS. You can then check the calibraon by weighing your
calibraon weight.
TOTARETHESHACKLE
Make sure the display shows 0.000 KGS if not press TARE. Power off the
weigher and aach the shackle. Power on the weigher and press the
TARE key. The weigher will tare out the shackle weight and show
0.000 KGS. This tared weight will stay in the weigher unl another tare is
done.
SETUPOPTIONS
To reset the weigher back to Factory sengs hold the MEMORYSTORE
buon and turn on. The display will show WELTECHSETUPunl the
buon is released, when the buon is released FACTORYRESETwill be
displayed, press ENTER to change sengs. The display will show
DISPLAYSTYLE, it can be set to metric or USA by pressing the INC
arrow, when set press ENTER, The display will show WEIGHTRANGE
and CHICKEN will flash, push ENTER. The display will now show FULL
FEATURESand ON will flash, press ENTER. HOUR will then show on the
display and the correct me can now be set by using the INC or DEC
arrows. Once the correct hours have been set press ENTER, the correct
minutes, day, month and year can be set the same way. When
completed the display will show AREYOUSURE, follow the instrucons
on the display and it will show INITIALZING followed by SAVINGNEW
SETTINGS.
The display will then revert to normal.
THE WEIGHER WILL NOW NEED CALIBRATING.
See page 2
3
2