REMOTECOMMANDS
The following commands are accepted at the serial port.
ID? Send id message
ALL? Send vercal every bird list for current store
WGT? Send current weight
DATA? Send summary report for current store
HYST? Send histogram for current report
TARG? Send target weight
TARG,nnnn Set target weight
DUMP? Send all weights
STATS Send a stascs summary
SER? Send serial number
EACH Turns on the each bird print
EAOFF Turns off the each bird print
HYON Turns on the histogram print
HYOFF Turns off histogram print
STON Turns on stasc print
STOFF Turns off the stasc print
UP Send bird dump in binary Data Pod format
DATE? Send the date ddmmyy
TIME? Send the me hhmm
DATE,ddmmyy Set the date ddmmyy
TIME,hhmm Set the me hhmm
CLEAR Clear memory
PRINT Print standard reports
SETTS Print sengs report
RESET Restart the processor
OFF Power down
16
USINGTHEUSB
Turn weigher on and open PRINTOPTIONS, and make sure WRITETO
USBis on.
Plug USB sck into port (Shown on page 15) and press PRINTDATA.
Once the file is wrien FILEWRITTENOKwill appear on the screen, the
data is now downloaded. Remove the USB sck from the weigher and
plug into your computer.
Go to MYCOMPUTERand open USBDISKFILES. Now select all the files
and right click, a small dropdown menu should appear with the opon
OPENWITH..now select CHOOSEDEFAULTPROGRAMand select
MICROSOFTEXCEL.
Or
Open Microso Excel. Select FILE in the top le corner and then click
OPEN. It will now open a small window, click on MYCOMPUTERand
select the USBDISKicon. Select all the files you want to see and then
click open. (You selected mulple files by holding down CTRL and
clicking each file)
17
To Next Page
Loading...